A reboot with 2.4.0-test7 (on i386 at least) doesn't properly "release" the card and hang the computer after displaying Linux PCMCIA options, just before YENTA IRQ is displayed no matter which kernel is then used to boot or segfault windows 98SE. Only way is to turn down computer. With the same machine (Dell Inspiron 7000) and card (D-Link DMF-560TXD) and a 2.3.99-pre9 (ie before the Linus reboot "improvement") everything was working fine. Going to sleep mode (APM, APIC not tested) and turning back on doesn't restore IP address with 2.4.0-test7 while it does using 2.3.99-pre9 Doing the following sequence with my D-Link DMF-560TXD (combo 56k/10/100Mb) block any sort of transmission through the modem (other sequence might lead to the same?!): - connect Internet with the modem - connect to an ethernet switch (link beat) - disconnect from the switch (unlink) reconnecting to the switch (new link beat) is then the only way of continuing sending/receiving through the modem (!This has not been tested yet with other kernel than the 2.4.0-test7) (For David) By upgrading my pcmcia-cs package, I noticed that cardmgr.c includes <pcmcia/version.h> which by the cc option -I refers to the pcmcia/version.h from the kernel instead(?) of the one from the pcmcia-cs package /\/\arceric - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] Please read the FAQ at http://www.tux.org/lkml/
