On Jun 4, 2010, at 9:36 AM, Dan Shimshoni wrote:

First of all, wifi in Israel is heavily regulated. It's limited to 100mw EIRP (radiated) power, so gain antennas, higher power transmitters, etc are illegal here. If you use a gain antenna, you have to offset it by reducing output power or using a long feed line, which has a lot of loss, so it effectively does it anyway. The one exception if the omnidirectional desktop and weatherproof antennas, which are not very much gain (3dbd) so it does not matter.

The first way to improve things is to use a desktop gain antenna on your router or at the PC end. Here's one I put on my access point, which I got from BUG. Note that it only improves signals 6db which is about 4 times. Most of that improvment is really phantom as the antenna normally supplied by an access point or router vendor is so lossy, you really are gaining back what you lost before with the bad antenna.

http://www.bug.co.il/prodtxt.asp?id=6357&perur=4

Antenna polarization is important. At the frequencies involved the loss due to the wrong polarization is over 20db (100 times). So keep all of your antennas vertical or horizontal.

You can legally "cheat" by using a real gain antenna if your access point or router allows you to use two antennas, one for reception, one for transmission. Then you can use a high gain directional antenna for reception, which is unregulated, and a low gain omnidirectional antenna for transmission, which is.

Another way to do it is to move your access point to a spot closer to both computers, which may be tricky because it is not necessarily in the middle. Paper, fiberboard (cheap furniture) and metal (including re-enforced concrete walls) absorb or block wifi signals, so sometimes moving them helps.


Adding another access point also helps, but it requries an ethernet cable between them. Every wifi router I have ever used supports this, you turn on bridging, turn off DHCP, and connect a LAN port to the LAN port of the other router. Make sure before you disconnect it during set up to assign it a fixed IP address on your network, or it will get lost or conflict with the other router(s).

It should be set to the same SSID, encryption type and keys, but a DIFFERENT channel. Any computer connected to your network will automaticaly roam to the strongest signal. Make sure to use a unique SSID (obvious not default, siemens, attwifi, etc, and use it on all your access points that are connected together.

You can also use most routers, if you are tricky as Wifi adaptors (or just buy a gaming adaptor) so that could be used to extend the PC to the network. It does require an ethernet cable.

There are ways of extending a network wirelessly (look up MESH networks), Their big disadvantage is that the receive a packet of data and then retransmit it back on the same channel. This cuts your network throughput down to a third or so because not only does each packet get transmitted twice, there are delays built in to prevent two stations transmiting at the same time, so they are magnified too.

BTW, signals interfere with each other, so if you have any other transmitting device, whether its on the same channel or not, keep it at least a meter from any other. I found that on my Mac with a wifi CARDBUS card (802.11g) or the built in 802.11b card, I lost about 10% of the wifi signal if I had a bluetooth dongle plugged in. Moving the dongle to the far end of a meter USB extension cable fixed that problem.

I have 2 separate wifi networks, one 802.11b and the other 802.11g, and two DECT phone bases. The closest they are is about 4 meters apart, but the 2 wifi routers, and one of the DECT bases are in different rooms.

Geoff.
--
geoffrey mendelson N3OWJ/4X1GM
Jerusalem Israel geoffreymendel...@gmail.com
New word I coined 12/13/09, "Sub-Wikipedia" adj, describing knowledge or understanding, as in he has a sub-wikipedia understanding of the situation. i.e possessing less facts or information than can be found in the Wikipedia.







_______________________________________________
Linux-il mailing list
Linux-il@cs.huji.ac.il
http://mailman.cs.huji.ac.il/mailman/listinfo/linux-il

Reply via email to