Hi, Last time I asked about routing issue on a wifi connected machine. Today I have noticed that this happens also on my *wired* machine.
My resolv.conf file is 2 lines to the router: nameserver 192.168.1.1 and to Netvision (194.90.1.5) My routing is very simple one: $ /sbin/route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.1.0 * 255.255.255.0 U 0 0 0 eth0 169.254.0.0 * 255.255.0.0 U 0 0 0 eth0 default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0 The weird part? running the "route" (without any parameters) shows me the routing correctly if I run the "route" command 6-7 times over, but in the 8th time (more or less) I see the IP's, then it wait 2-4 seconds and then it shows the "default" line. I really don't have any explanation for it. I even tried to remove the resolv.conf, and it had no impact at all. Suggestions? Thanks, Hetz -- my blog (hebrew): http://benhamo.org Skype: heunique MSN: hetz-b...@benhamo.org
_______________________________________________ Linux-il mailing list Linux-il@cs.huji.ac.il http://mailman.cs.huji.ac.il/mailman/listinfo/linux-il
