Hi,
On Tue, May 27, 2008 at 11:31 PM, Tzafrir Cohen <[EMAIL PROTECTED]>
wrote:
> On Sun, May 25, 2008 at 07:35:47PM +0300, Arie Skliarouk wrote:
> > Hi,
> >
> > I am trying to set up CallerID for asterisk on Digium 100P card, but so
> far,
> > every time there is incoming call, there is following warning in
> > /var/log/asterisk/messages:
> > [May 25 19:10:59] WARNING[1041] chan_zap.c: CallerID returned with error
> on
> > channel 'Zap/1-1'
>
> What do you have on zapata.conf?
[trunkgroups]
[channels]
language=en
context=default
switchtype=national
signalling=fxs_ks
; where the ring cadence is changed *after*
the callerid spill.
usecallerid=yes
hidecallerid=no
callwaiting=no
usecallingpres=yes
callwaitingcallerid=yes
threewaycalling=yes
transfer=yes
canpark=yes
cancallforward=yes
callreturn=yes
echocancel=yes
echocancelwhenbridged=yes
echotraining=no
echotraining=800
rxgain=0.0
txgain=0.0
group=1
channel=1 ;Must match channel # in zaptel.conf
callgroup=1
pickupgroup=1
immediate=yes
callerid=asreceived
busydetect=yes
busycount=8
busypattern=500,500
Can you test this line with a caller-id-enabled phone?
I have an called-id enabled phone connected along the card, and see there
the Called-ID.
On internet someone suggested to make the Wildcard TDM400P card not to share
IRQ with any other device. In my case the IRQ was shared with audiocard, but
disabling the audiocard have not helped.
Other suggestion was to move the TDM400P to phone line that is not connected
to ADSL.
Do someone here uses the card on ADSL-less line with working Caller-ID?
> > What is the proper configuration in file zapata.conf (especially settings
> > cidsignalling and cidstart) for the CallerID to be properly recognized in
> > Israel?
>
> The defaults (cidsignalling=bell)
Tried with that and without (default), the same result.
--
Arie
