Hi list...
I'm connected to an external storage machine (like EMC). When I allocate
new disk I need to unload and load my FC (fiberchannel card) card (Emulex
or Qlogic) module.
Rescan_scsi_bus isn't working also...
If I do
# echo "scsi add-single-device 6 0 0 2 " > /proc/scsi/scsi
when "6 0 0 2" is not "set" on the machine. after the module is reloaded I
can see that disk... (Host: scsi6 Channel: 00 Id: 00 Lun: 02)
then I get nothing, but if I do
# echo "scsi remove-single-device 6 0 0 1 " > /proc/scsi/scsi
when the "6 0 0 1" is aworking device...
(Host: scsi6 Channel: 00 Id: 00 Lun: 01)
and then
# echo "scsi add-single-device 6 0 0 1 " > /proc/scsi/scsi
so I can add it...
I can see this is working (just to see that this method of adding devices is
working)?
Is there a way to scan the scsi ports without unloading the FC card module?
TIA,
Gili
=================================================================
To unsubscribe, send mail to [EMAIL PROTECTED] with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail [EMAIL PROTECTED]
