I have recently switched to a new motherboard and a cpu in my computer. In
the previous one I was using the usb keyboard and mouse and it was working
fine. After I switched to a new motherboard I started having problems. At
Windows, both the keyboard and mouse work perfectly. At linux, the system
boots without showing any unusual messages, but right after the login
prompt it starts printing the endless sequence of '%' characters. The
keyboard works, i.e. I can type whatever I want, but the %'s get
between any two-three letters I type. If I plug the keyboard out, it stops,
but resumes a couple of seconds after I plug it in. If I connect the keyboard
with the ps/2 connector, it works -- that's how I type this letter. I'm
completely clueless, even google shows nothing
Cheers, L.
PS:
My configuration is as follows: P4 2.8Ghz, P4P800, USB controllers as mentioned below, Gentoo Linux, kernel 2.6.2.
PPS. From 'lspci -v':
00:1d.0 USB Controller: Intel Corp. 82801EB USB (rev 02) (prog-if 00
[UHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0, IRQ 16
I/O ports at eec0 [size=32]00:1d.1 USB Controller: Intel Corp. 82801EB USB (rev 02) (prog-if 00
[UHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0, IRQ 19
I/O ports at ef00 [size=32]00:1d.7 USB Controller: Intel Corp. 82801EB USB2 (rev 02) (prog-if 20
[EHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0, IRQ 23
Memory at febff800 (32-bit, non-prefetchable) [size=1K]
Capabilities: [50] Power Management version 2
Capabilities: [58] #0a [20a0]
PPPS: From .config: # USB support # CONFIG_USB=y # CONFIG_USB_DEBUG is not set
# # Miscellaneous USB options # CONFIG_USB_DEVICEFS=y # CONFIG_USB_BANDWIDTH is not set # CONFIG_USB_DYNAMIC_MINORS is not set
# # USB Host Controller Drivers # CONFIG_USB_EHCI_HCD=m # CONFIG_USB_OHCI_HCD is not set CONFIG_USB_UHCI_HCD=y
# # USB Human Interface Devices (HID) # CONFIG_USB_HID=y CONFIG_USB_HIDINPUT=y # CONFIG_HID_FF is not set CONFIG_USB_HIDDEV=y # CONFIG_USB_AIPTEK is not set # CONFIG_USB_WACOM is not set # CONFIG_USB_KBTAB is not set # CONFIG_USB_POWERMATE is not set # CONFIG_USB_XPAD is not set
================================================================= To unsubscribe, send mail to [EMAIL PROTECTED] with the word "unsubscribe" in the message body, e.g., run the command echo unsubscribe | mail [EMAIL PROTECTED]
