you have to set the default gateway to the ppp0.
see your /etc/ppp/options (and add defaultgateway there?).
Dani
On Sat, 3 Feb 2001, Boaz Ben-Yaacov wrote:
> I am still not able to telnet, or even ping out from the system. although now after
>applying the patch (provided by mulix) I "seem" to be connected
> I think I might be incurring problems with my linuxconf settings, below is what I
>get when I run "ifconfig -a" and netstat -r -n respectively:
>
> ****notice on the bottom the gateway for eth0
>
> eth0 Link encap:Ethernet HWaddr 00:50:DA:CC:51:41
> inet addr:10.200.1.1 Bcast:10.255.255.255 Mask:255.0.0.0
> UP BROADCAST RUNNING MULTICAST MTU:1452 Metric:1
> RX packets:512 errors:0 dropped:0 overruns:0 frame:0
> TX packets:648 errors:0 dropped:0 overruns:0 carrier:2
> collisions:0 txqueuelen:100
> Interrupt:5 Base address:0x1080
>
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Mask:255.0.0.0
> UP LOOPBACK RUNNING MTU:3924 Metric:1
> RX packets:120 errors:0 dropped:0 overruns:0 frame:0
> TX packets:120 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:0
>
> ppp0 Link encap:Point-to-Point Protocol
> inet addr:213.57.49.31 P-t-P:213.57.49.1 Mask:255.255.255.255
> POINTOPOINT NOARP MULTICAST MTU:1452 Metric:1
> RX packets:24 errors:0 dropped:0 overruns:0 frame:0
> TX packets:16 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:10
>
> Kernel IP routing table
> Destination Gateway Genmask Flags MSS Window irtt Iface
> 213.57.49.1 0.0.0.0 255.255.255.255 UH 0 0 0 ppp8
> 10.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 eth0
> 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
> 0.0.0.0 10.255.255.254 0.0.0.0 UG 0 0 0 eth0
>
>
> Boaz Ben-Yaacov
>
=================================================================
To unsubscribe, send mail to [EMAIL PROTECTED] with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail [EMAIL PROTECTED]
