I think it is Ctrl,Alt,+ and Ctrl,Alt,-
----- Original Message -----
From: "Arieh Bibliowicz" <[EMAIL PROTECTED]>
To: "Linux-IL" <[EMAIL PROTECTED]>
Sent: Friday, January 26, 2001 10:38 AM
Subject: Re: AverMedia TVCapture Card
> I finally configured my TVCard, but I work on resolution 1240x1024, so
when
> I put the prog on full screen I don't get the image to fill the screen.
Does
> anyone know how to change the resolution in X on run time (if you can do
it
> in windows, it has to be available in Linux)? because at 640x480 the image
> fills the screen.
>
> Arieh
>
> ----- Original Message -----
> From: "Ilya Konstantinov" <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Cc: "Linux-IL" <[EMAIL PROTECTED]>
> Sent: Friday, January 26, 2001 1:34 AM
> Subject: Re: AverMedia TVCapture Card
>
>
> > On Fri, Jan 26, 2001 at 12:56:36AM +0200, [EMAIL PROTECTED] wrote:
> > > I have a problem with my FlyVideo TVCard. I had succsesfully
configured
> it
> > > to show good video. But without sound.
> > > Which module to install to complete this installation? or (which tuner
> type
> > > does it have?).
> >
> > I don't remember which tuner type it was for FlyVideo, but there aren't
> > that many to try (1 to 8).
> >
> > 1. You have the audio connection to your sound card, and Line-In's
volume
> > in the mixer is high enough, right?
> > 2. bttv supports lots of Bt848 TV cards. Apparently, turning the Bt848
> > on isn't a big deal - it's the same on all the cards. What differs
> > is how they activate the audio chip.
> >
> > FlyVideo should be bttv card=8 or card=30 (for FlyVideo 98).
> > (that's from 2.4's CARDLIST file)
> >
> > You might also read Documentation/video4linux/bttv/Sound-FAQ
> > from the kernel's tree.
> >
> > --
> > Best regards,
> > Ilya Konstantinov
> >
> > =================================================================
> > To unsubscribe, send mail to [EMAIL PROTECTED] with
> > the word "unsubscribe" in the message body, e.g., run the command
> > echo unsubscribe | mail [EMAIL PROTECTED]
> >
> >
>
>
> =================================================================
> To unsubscribe, send mail to [EMAIL PROTECTED] with
> the word "unsubscribe" in the message body, e.g., run the command
> echo unsubscribe | mail [EMAIL PROTECTED]
>
>
=================================================================
To unsubscribe, send mail to [EMAIL PROTECTED] with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail [EMAIL PROTECTED]
