I've installed RH6.0 on 3 computers with 8 Giga SCSI drives on a more than 5G partition. Lilo worked fine, out of the box. no tinkering was necessary. I assume you just saw the fdisk warning and was scared. If you have an actual problem - I'd like to see the problem (what does lilo say? what is in your lilo.conf?) Chen. ----- Original Message ----- From: Ben-Nes Michael <[EMAIL PROTECTED]> To: ILUG <[EMAIL PROTECTED]> Sent: Monday, December 20, 1999 4:11 PM Subject: lilo/scsi > Hi > > Lilo is not working with scsi :-( > what should i do/read to solve this proble ? > > fdisk /dev/sda > > The number of cylinders for this disk is set to 1115. > There is nothing wrong with that, but this is larger than 1024, > and could in certain setups cause problems with: > 1) software that runs at boot time (e.g., LILO) > 2) booting and partitioning software from other OSs > (e.g., DOS FDISK, OS/2 FDISK) > > > > -- > -------------------------- > Canaan Surfing Ltd. > Internet Service Providers > Ben-Nes Michael - Manager > Tel: 972-6-6925757 > Fax: 972-6-6925858 > http://www.canaan.co.il > -------------------------- > > > > ================================================================= > To unsubscribe, send mail to [EMAIL PROTECTED] with > the word "unsubscribe" in the message body, e.g., run the command > echo unsubscribe | mail [EMAIL PROTECTED] ================================================================= To unsubscribe, send mail to [EMAIL PROTECTED] with the word "unsubscribe" in the message body, e.g., run the command echo unsubscribe | mail [EMAIL PROTECTED]
