On Thu, 11 Nov 1999, Ohad M. Somjen wrote:
> hi,
> is there somebody in this list
> that was successful in installing
> two Intel EtherExpress Pro/10+ in
> one computer.
> i configured them right with
> isapnp (they are ISA cards)
> and i can activated them separatly
> using:
> #>modprobe eepro io=0x300 irq=3
> #>modprobe eepro io=0x200 irq=9
>
> but with that i get only one card
> up and running. the eepro module is
> supposed to probe the above io-ports
> so i try doing:
> #>modprobe eepro
> butthe computer hangs up completely
> and the only way out is but pressing
> the reset button.
>
> any help appriciated,
> TIA,
> Ohad.
>
I believe that you are wasting your time with modules. Compile the support
directly into the kernel and then use
append = "reserve=0x200,32 ether=0,0x200,eth1"
in /etc/lilo.conf.
Regards,
- yba
EE 77 7F 30 4A 64 2E C5 83 5F E7 49 A6 82 29 BA ~. .~ TclTek Ltd.
=}-------------------------------------------------ooO--U--Ooo-----------{=
- [EMAIL PROTECTED] - tel: +972.52.670.353, http://www.tcltek.co.il -
=================================================================
To unsubscribe, send mail to [EMAIL PROTECTED] with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail [EMAIL PROTECTED]
