Hi there, This is my first post on this list, so hello everybody :)
I am currently testing the fun of Linux HA Clustering (just for personal interest) and I have successfully set up a tiny ubuntu virtualbox 2 nodes cluster with Ip failover and Apache running as resources. Right after the install, I tried to move the resources from a node to the other (command standby) an everything worked like a charm. Then I tried some failure tests, and started with a simple /etc/init.d/networking stop on one node, noticed that the other node took ownership of the resources automatically, all was fine. Then I have rebooted the nodes just to see how they would restart the cluster, and since I have the following error : apache_start_0 (node=node1, call=8, rc=1, status=complete): unknown error For reading convenience, my outputs are available at http://pastebin.com/w1J4TWaG Just to clarify, that's : - crm configure show command - crm_mon status - All relevant information into my /var/log/syslog (although I was not sure what to look at, I never used corosync before) I have read on an older post that the apache error usually have something to do with either timeout or mod status. As you can see on my pastebin, my timeout values are ok : op stop interval="60s" timeout="120" \ op start interval="60s" timeout="120" \ as for mod_status it's already enabled in Apache : root@node1:/etc/apache2# a2enmod status Module status already enabled Have I done anything wrong or is there anything else I should check/configure ? Any help with this matter would be greatly appreciated :) Thanks, Guillaume _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
