On 9/27/07, Junko IKEDA <[EMAIL PROTECTED]> wrote: > Hello, > > I found the following crm_standby behavior when I tried one SplitBrain case. > ( I have many test cases on it... ) > > It goes like this. > shortly after the disconnecting interconnect LAN, > I issued crm_standby command immediately on one node which was not DC. > It seemed that crm_standby tried to connect the CIB master, but it was not > able to, > because interconnect LAN has been cut already. > after recovering SplitBrain, crm_standby could return an error message, > like "Error performing operation: not connected". > > Is it possible to set a time-out period to crm_standby or others command? > it's boring to wait its return for quite a while if it fails.
it's certainly possible and i'd be happy to apply such a patch if you send it :-) > > This topic might be the same as this; > http://www.gossamer-threads.com/lists/linuxha/dev/36926 > if so, are there any progresses? > > Best Regards, > Junko Ikeda > > NTT DATA INTELLILINK CORPORATION > > _______________________________________________ > Linux-HA mailing list > [email protected] > http://lists.linux-ha.org/mailman/listinfo/linux-ha > See also: http://linux-ha.org/ReportingProblems > > _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
