Hi Merlin, You have to start the PC using UEFI boot via PXE (instead of legacy) - than grub-install installs the efi-based grub when called by FAI.
Cheers Sven > Am 26.11.2019 um 19:37 schrieb CSCI Technician <t...@csci.viu.ca>: > > Hi Bob, > > Thanks for the reply and tip. This was actually the first issue that I had... > I had forgot to change disk_config. This is what I currently have in my > disk_config: > > disk_config nvme0n1 disklabel:gpt bootable:1 fstabkey:uuid > > primary /boot/efi 512 vfat rw > primary /boot 2048 ext4 rw > primary - 4096- - - > > and then the rest is configuring LVM. > In looking at the client system when the install is running I do see that > both /boot and /boot/efi are mounted. > > As Thomas pointed out though, and I confirmed, /sys/firmware/efi is not > present on the client or in /target on the client. I believe this is my next > hurdle. > > Cheers, > Merlin. > > >> On 11/26/19 7:19 AM, Bob A via linux-fai wrote: >> Diese Nachricht wurde eingewickelt um DMARC-kompatibel zu sein. Die >> eigentliche Nachricht steht dadurch in einem Anhang. >> >> This message was wrapped to be DMARC compliant. The actual message >> text is therefore in an attachment. > > I suspect you do not have a "vfat" partition as required for UEFI. Something > like this in disk_config should do the trick: > > disk_config disk1 disklabel:gpt bootable:1 fstabkey:uuid > primary /boot/efi 512M vfat rw > primary / 8192- ext4 rw,errors=remount-ro createopts="-L > root" > primary swap RAM:100% swap sw createopts="-L > swap" > > > I may be forgetting another step, but hopefully this will be a step in the > right direction for you. > > -- > Merlin Hansen > Department of Computing Science > Vancouver Island University > 900 Fifth Street > Nanaimo BC V9R 5S5 > 250-753-3245 x 2321 > t...@csci.viu.ca >
