From: "tom wa" <[EMAIL PROTECTED]>>
----- Original Message -----
Trouble is that I still get no data from adapter0/dvr0. I'm going to try to build from source since the version of szap in Debian comes from version 1.0.1.
Well, I've rebuilt the modules and apps from the main distribution and from CVS and I'm no more closer to getting things working :'(
The card is a skystar II 2.6b
Here's debug output from when I'm using szap:
Jun 15 21:01:45 bubbles kernel: flexcop_diseqc_ioctl: FE_SET_VOLTAGE Jun 15 21:01:45 bubbles kernel: flexcop_diseqc_ioctl: SEC_VOLTAGE_18, 1 Jun 15 21:01:45 bubbles kernel: set_tuner_polarity : polarity = 2 Jun 15 21:01:48 bubbles kernel: dvb_start_feed: PID=401, type=0 Jun 15 21:01:48 bubbles kernel: filter_enable_mask_filter: op=1 Jun 15 21:01:48 bubbles kernel: add_pid: pid=401 Jun 15 21:01:48 bubbles kernel: add_hw_pid: pid=401 Jun 15 21:01:48 bubbles kernel: add_hw_pid: pid=401 searching slot=0 Jun 15 21:01:48 bubbles kernel: add_hw_pid: pid=401 slot=0 Jun 15 21:01:48 bubbles kernel: pid_set_hw_pid: id=0 pid=401 Jun 15 21:01:48 bubbles kernel: pid_set_hw_pid: id=0 addr=300 l pid=401 Jun 15 21:01:48 bubbles kernel: filter_enable_hw_filter: id=0 op=1 Jun 15 21:01:48 bubbles kernel: open_stream: adapter->dma_status=30000000 Jun 15 21:01:48 bubbles kernel: dma_start_stop: dma_mask=3 Jun 15 21:01:48 bubbles kernel: dma_start_stop: starting dma Jun 15 21:01:48 bubbles kernel: dvb_start_feed: PID=402, type=0 Jun 15 21:01:48 bubbles kernel: filter_enable_mask_filter: op=1 Jun 15 21:01:48 bubbles kernel: add_pid: pid=402 Jun 15 21:01:48 bubbles kernel: add_hw_pid: pid=402 Jun 15 21:01:48 bubbles kernel: add_hw_pid: pid=402 searching slot=0 Jun 15 21:01:48 bubbles kernel: add_hw_pid: pid=402 searching slot=1 Jun 15 21:01:48 bubbles kernel: add_hw_pid: pid=402 slot=1 Jun 15 21:01:48 bubbles kernel: pid_set_hw_pid: id=1 pid=402 Jun 15 21:01:48 bubbles kernel: pid_set_hw_pid: id=1 addr=300 h pid=402 Jun 15 21:01:48 bubbles kernel: filter_enable_hw_filter: id=1 op=1 Jun 15 21:01:48 bubbles kernel: open_stream: adapter->dma_status=30000007
Thanks again!
That looks good. The FlexCop is running and the PID-filters are established. Now all you have to do is keep szap running *with the -r switch* in one console while starting mplayer in another.
That should work.
hth,
Niklas
