Hello to everybody involved in this great project!
I have had a problem for a while now, I have a Fujutsu
Siemens DVB-S v1.3 cards and the problem is this the
tuner runs very
hot... I have tried cooling it with a coolerblock and
a fan mounted on the tuner, but it doesn't work that
good...
So now I'm looking into having the tuner changed...
I have found a new tuner from ALPS that seems very
good the problem is this; the tuner is not directly
supported from the
drivers that are avaible today...
It works almost the same as the BSRU6, the only
diffrence is in two commands.
>From the BSBE1_701A.pdf:
"The difference between the BSRU6 and the BSBE1
We have changed some datas of PLL_controller and a
QPSK-demod. for operating the BSBE1.
So if yiu operate the BSBE1 with a software of the
BSRU6, you can not operate the BSBE1.
You have to change data of PLL_controler. But it's a
little change (only 2bits).
Please change a data for operating the BSBE1.
1) PLL_ccontrol data Byte5 bit5[XCE] "0" -> "1"
BSRU6... Byte5=C0(Hex)
*BSBE1... Byte5=E0(Hex)
2) Control data (QPSK-Demod.) Sub
address=0F(Hex)[AGC1R] bit7[lagc] "0" -> "1"
BSRU6... Add. 0F(Hex)=12(Hex)
*BSBE1... Add. 0F(Hex)=92(Hex)
3) RF_input Level vs. AGC1 value
The AGC-curve will change from BSRU6."
So now I wonder if these changes could be applied to
the drivers so that this tuner also would work.
Hope someone can help me and others wih this...
Best regards!
__________________________________
Do you Yahoo!?
Yahoo! Mail - More reliable, more storage, less spam
http://mail.yahoo.com
--
Info:
To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as
subject.
