Hello Oliver,

Hello, I have a reproducable error with the 1.1.1 release. When zapping: ARD, ZDF, RTL1, RTL2, VOX, SAT1 the screen gets black when reaching SAT1, and afterwards I can tzap to whatever I want. The screen stays black. With 1.0.1 everything works ( and zapping is faster ). I am using a 2.4.25 Kernel with vdr 1.35 ( I don't use 2.6.x anymore, because then I cannot switch back to the good old drivers

Isn't here anybody interested ? As I said it's easy to reproduce, here are my settings for the channels: I am using a DVB-S rev. 1.3 channels.conf:



No problems here with DVB-S 2.1. Kernel 2.4.25, vdr 1.3.5. Are you using vdr 1.3.5 or 1.1.35? Your channels.conf doesn't not look like a vdr 1.3.5 file:



Das Erste:11837:h:S19.2E:27500:101:102:104:0:28106:0:0:0


Yes its vdr 1.3.5 - The same happens with vdr 1.2.6.



diseqc.conf
S19.2E 11700 V 9750 t v W15 [E0 10 38 F0] W15 A W15 t S19.2E 99999 V ...





It seems to be that switching to vertical position kills everything.



Maybe timing has changed slightly (for whatever reason). Try to optimize your DiSEqC setup. This might speed-up tuning:

full DiSEqC sequence:
S19.2E 11700 V 9750 [E0 10 38 F0] [E1 10 38 F0] [E1 10 38 F0] S19.2E 99999 V 10600 [E0 10 38 F1] [E1 10 38 F1] [E1 10 38 F1] S19.2E 11700 H 9750 [E0 10 38 F2] [E1 10 38 F2] [E1 10 38 F2] S19.2E 99999 H 10600 [E0 10 38 F3] [E1 10 38 F3] [E1 10 38 F3]


I'm using this setup for a long time now (vdr 1.1.x).
It works perfectly.


I'll give it a try - my diseqc.conf and channels.conf are working fine with the 1.01 drivers but not with 1.1.x



Once again ( I don't give up too fast :-).
Isn't here anyone experiencing the same problem ?



Obviously, no one has your problem.


Thats not right - on vdrportal this error was also reported.

Bye
Helmut



--
Info:
To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as 
subject.



Reply via email to