Add device tree bindings for PCI endpoint function device. The
nodes for PCI endpoint function device should be attached to
PCI endpoint function bus.
Signed-off-by: Kishon Vijay Abraham I <kis...@ti.com>
---
.../bindings/pci/endpoint/pci-epf.txt | 28 +++++++++++++++++++
1 file changed, 28 insertions(+)
create mode 100644 Documentation/devicetree/bindings/pci/endpoint/pci-epf.txt
diff --git a/Documentation/devicetree/bindings/pci/endpoint/pci-epf.txt
b/Documentation/devicetree/bindings/pci/endpoint/pci-epf.txt
new file mode 100644
index 000000000000..f006395fd526
--- /dev/null
+++ b/Documentation/devicetree/bindings/pci/endpoint/pci-epf.txt
@@ -0,0 +1,28 @@
+PCI Endpoint Function Device
+
+This describes the generic bindings to be used when a device has to be
+exposed to the remote host over PCIe. The device could be an actual
+peripheral in the platform or a virtual device created by the software.
+
+epcs : phandle to the endpoint controller device
+epc-names : the names of the endpoint controller device corresponding
+ to the EPCs present in the *epcs* phandle
+vendor-id: used to identify device manufacturer
+device-id: used to identify a particular device
+baseclass-code: used to classify the type of function the device performs
+subclass-code: used to identify more specifically the function of the device
+subsys-vendor-id: used to identify vendor of the add-in card or subsystem
+subsys-id: used to specify an id that is specific to a vendor
+
+Example:
+Following is an example of NTB device exposed to the remote host.
+
+ntb {
+ compatible = "pci-epf-ntb";
+ epcs = <&pcie0_ep>, <&pcie1_ep>;
+ epc-names = "primary", "secondary";
+ vendor-id = /bits/ 16 <0x104c>;
+ device-id = /bits/ 16 <0xb00d>;
+ num-mws = <4>;
+ mws-size = <0x100000>, <0x100000>, <0x100000>, <0x100000>;
+};
--
2.17.1
