Hi all,
this patchset makes it possible to calibrate ina2xx drivers with different
calibration values, which are calculated using max expected current value.
It can be read from device tree, platform data or changed during run-time
using sysfs. If it isn't specified in device tree or platform data, the
driver uses default value, thanks to which the behaviour of the driver
don't change in this case.
There are two drivers for ina2xx: hwmon and iio. Changes are made
for both of them and their bindings as well.
These changes allow setting sensor's precision to the required by the board.
It is useful in Odroid XU3. Therefore this patchset also sets
max-expected-current in OdroidXU3 device tree to values from documentation.
Best Regards,
Maciej Purski
Maciej Purski (4):
iio: adc: ina2xx: Make max expected current configurable
hwmon: (ina2xx) Make max expected current configurable
dt-bindings: hwmon: Add max-expected-current property to ina2xx
ARM: dts: Add max-expected-current properties for ina231 in Odroid XU3
Documentation/devicetree/bindings/hwmon/ina2xx.txt | 4 +-
Documentation/hwmon/ina2xx | 9 +-
arch/arm/boot/dts/exynos5422-odroidxu3.dts | 4 +
drivers/hwmon/ina2xx.c | 105 +++++++++++++++++---
drivers/iio/adc/ina2xx-adc.c | 110 ++++++++++++++++++---
include/linux/platform_data/ina2xx.h | 2 +
6 files changed, 203 insertions(+), 31 deletions(-)
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
