From: Balaji T K <balaj...@ti.com> Use OMAP_HSMMC_SUPPORTS_DUAL_VOLT flag instead of host->id for identifying SD bus voltage capabilities.
Signed-off-by: Balaji T K <balaj...@ti.com> Signed-off-by: Rajendra Nayak <rna...@ti.com> Tested-by: Venkatraman S <svenk...@ti.com> --- drivers/mmc/host/omap_hsmmc.c | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-) diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c index 9955aee..91faf42 100644 --- a/drivers/mmc/host/omap_hsmmc.c +++ b/drivers/mmc/host/omap_hsmmc.c @@ -650,7 +650,7 @@ static int omap_hsmmc_context_restore(struct omap_hsmmc_host *host) OMAP_HSMMC_WRITE(host->base, SYSCONFIG, OMAP_HSMMC_READ(host->base, SYSCONFIG) | AUTOIDLE); - if (host->id == OMAP_MMC1_DEVID) { + if (host->pdata->controller_flags & OMAP_HSMMC_SUPPORTS_DUAL_VOLT) { if (host->power_mode != MMC_POWER_OFF && (1 << ios->vdd) <= MMC_VDD_23_24) hctl = SDVS18; -- 1.7.1 _______________________________________________ linaro-dev mailing list linaro-dev@lists.linaro.org http://lists.linaro.org/mailman/listinfo/linaro-dev