On Tue, 2011-06-07 at 10:01 +0100, Andy Green wrote:
> On 06/07/2011 09:35 AM, Somebody in the thread at some point said:
> 
> >>> Disabling Thumb2 fixes the problem.
> >>
> >> What did you actually disable?  Presumably not CONFIG_THUMB2_KERNEL so
> >> the thumb support at all?
> >
> > I deselected CONFIG_THUMB2_KERNEL using menuconfig, which changed
> > the .config file like...
> >
> > -CONFIG_THUMB2_KERNEL=y
> 
> Yeah but where did this config come from?

It was the output produced by running the commands listed at
https://wiki.linaro.org/Resources/HowTo/KernelDeploy#From_Linaro_sources

This config has CONFIG_THUMB2_KERNEL=y and doesn't have an entry for
CONFIG_CPU_V6

>   Regenerating 
> omap2plus_defconfig as I showed doesn't allow CONFIG_THUMB2_KERNEL to be 
> configured because CONFIG_CPU_V6 is set (along with V7) since 
> omap2plus_defconfig has a bunch of different cores supported.
> 
> You mentioned -->
> 
> "The .config I'm using is that described on the wiki at
> https://wiki.linaro.org/Resources/HowTo/KernelDeploy#From_Linaro_sources";
> 
> it also recommends
> 
> make ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- omap2plus_defconfig

When I run that command I end up with a .config which has
CONFIG_CPU_V6=y and no entry for CONFIG_THUMB2_KERNEL.

> I just confirmed that's the case with current linux-linaro-2.6.39.  Am I 
> going nuts :?)

No, were using two different methods to produce configs. The one I use
produces a Thumb2 kernel, the one you use doesn't.

-- 
Tixy


_______________________________________________
linaro-dev mailing list
linaro-dev@lists.linaro.org
http://lists.linaro.org/mailman/listinfo/linaro-dev

Reply via email to