I used a \change Staff = "up" to get the D flat on the RH staff, but
because I needed to have a rest in the LH, I put both in separate voices.
%%%%Begin snippet
staffUp = \change Staff = "up"
...
<< {
| af [ b bf ( c ]
\oneVoice
| \staffUp df'2 ) ~ \f \fermata
| df8 r \acciaccatura { c8 } c,8 \sf r \break
} \\ {
\oneVoice
| s2 | R2 \fermataMarkup | R2
}
>>
%%%%End snippet
Knute Snortum
(via Gmail)
On Fri, May 9, 2014 at 8:32 AM, Phil Holmes <m...@philholmes.net> wrote:
> ----- Original Message ----- From: "Urs Liska" <u...@openlilylib.org>
> To: "lilypond-user" <lilypond-user@gnu.org>
> Sent: Friday, May 09, 2014 4:24 PM
> Subject: Fwd: [SPAM] Re: Slur that spans staves
>
>
>
> I assume you intended to write this to the list...
>>
>>
>> -------- Original-Nachricht --------
>> Betreff: [SPAM] Re: Slur that spans staves
>> Datum: Fri, 9 May 2014 08:23:56 -0700
>> Von: Knute Snortum <ksnor...@gmail.com>
>> An: Urs Liska <u...@openlilylib.org>
>>
>> Phil, that did it, thanks. I had to stand on my head a bit to get the
>> note
>> onto the upper staff, but I did it. Not pretty, but it works.
>>
>>
>> Knute Snortum
>> (via Gmail)
>>
>
>
> Don't think it's that hard. What was your solution?
>
> --
> Phil Holmes
>
> _______________________________________________
> lilypond-user mailing list
> lilypond-user@gnu.org
> https://lists.gnu.org/mailman/listinfo/lilypond-user
>
_______________________________________________
lilypond-user mailing list
lilypond-user@gnu.org
https://lists.gnu.org/mailman/listinfo/lilypond-user
