Hello Ed:
On 09/07/2013 07:38 PM, EdBeesley wrote:
Thanks Andrew I was going to do that but the whole part I'm writing has
the same beaming pattern throughout, so to keep it tidy I was hoping to
avoid doing it manually for every bar. And I figured I might as well try
and understand how it works now rather than later!
The relevant section of the manual is:
http://www.lilypond.org/doc/v2.16/Documentation/notation/beams#setting-automatic-beam-behavior
subsection: "beaming based on baseMoment and beatStructure"
from the manual: "If a common time signature is being used,
beamExceptions must be disabled to enable beatStructure to work. The
\set Timing.beamExceptions = #'() command can always be included if
beaming is being determined by beatStructure. "
I responded earlier with the code to automatically change the beaming
structure. I jumped at the opportunity to assist with this list as it
has been so very helpful to me in the past.
Rachael
_______________________________________________
lilypond-user mailing list
lilypond-user@gnu.org
https://lists.gnu.org/mailman/listinfo/lilypond-user
