As you might know, the documentation is going through a major revision
for the
moment. Could you please try to read Section "Voices contain music" in
http://web.uvic.ca/~gperciva/ -> GDP Docs -> Learning Manual
and comment on if you can figure out the answer to your question there.
(Since I know the answer, I know that it's explained there, even though
your
particular question isn't explicitly covered).
/Mats
Peter Siepmann wrote:
Thank you very much for your reply, Mats.
I'm using 2.10.25 and, as you say, the fragment I sent before compiles
fine on its own. The troubles arise when I put (single voice) notes
either side of it, such as :
R1 r4 fis2 eis4 dis2 cis4. cis8 b'4 b2 ais4 gis2. cis,4
<< { \voiceOne dis2( eis8 fis gis4) fis2 fis4. fis8 fis4 fis2 ~ fis4
gis2 ais4 r4} \\
\new Voice = "vII" { \voiceTwo dis,2 (eis8 dis cis b) ais2 b4.
dis8 cisis4 dis2( ais4) cis2 fis4 r4}
\lyricsto "vII" \new Lyrics {
mun -- di, mi -- se -- re -- re no -- bis.
}
>>
cis8. cis16 cis2 cis4 b2 cis4 r8 cis8 cis4 cis cis8 cis4 cis8 b2 cis4 r4
You see, this is part of a much larger score, and the lyrics to most
of the music is held in a separate \lyricmode { } block. But there
are one or two occasions when a single line splits into two parts; at
these points, the main lyrics seem to disappear, and so I tried coding
them in alongside the music as in the example above...
Your continued assistance is most gratefully appreciated!
Peter
--
=============================================
Mats Bengtsson
Signal Processing
Signals, Sensors and Systems
Royal Institute of Technology
SE-100 44 STOCKHOLM
Sweden
Phone: (+46) 8 790 8463
Fax: (+46) 8 790 7260
Email: [EMAIL PROTECTED]
WWW: http://www.s3.kth.se/~mabe
=============================================
_______________________________________________
lilypond-user mailing list
lilypond-user@gnu.org
http://lists.gnu.org/mailman/listinfo/lilypond-user
