Why not use \revert to reset these two properties to their default values (so you don't have to remember what the default is)? \revert MultiMeasureRest #'staff-position \revert Rest #'staff-position
/Mats
Thomas Scharkowski wrote:
\override Voice.MultiMeasureRest #'staff-position = #0
Hi Ole,
i strongly recommend the use of jEdit with lilypond plugin! It makes working with lilypond a lot easier.
Thomas
[EMAIL PROTECTED] wrote:
Try \override Voice.Rest #'staff-position = #0
That works _a bit_: all "normal" rests are there, where they should be, BUT all multi-measure-rests (R1) are separated again.
[EMAIL PROTECTED] wrote:
Use \revert Rest #'direction
Looks the same as above, but it generates a lot of warnings: "warning: rest direction not set. Cannot resolve collision".
So, what to do with the multi-measure-rests?
Ole
_______________________________________________ lilypond-user mailing list lilypond-user@gnu.org http://lists.gnu.org/mailman/listinfo/lilypond-user
_______________________________________________ lilypond-user mailing list lilypond-user@gnu.org http://lists.gnu.org/mailman/listinfo/lilypond-user
-- ============================================= Mats Bengtsson Signal Processing Signals, Sensors and Systems Royal Institute of Technology SE-100 44 STOCKHOLM Sweden Phone: (+46) 8 790 8463 Fax: (+46) 8 790 7260 Email: [EMAIL PROTECTED] WWW: http://www.s3.kth.se/~mabe =============================================
_______________________________________________ lilypond-user mailing list lilypond-user@gnu.org http://lists.gnu.org/mailman/listinfo/lilypond-user
