I'm afraid you forgot the attachment. Anyway, have you tried if
'ly2dvi -p myfile.ly' produces PDF files with the same problems?
Without seeing any example, it's really hard to see what your
problem might be.
Han-Wen, is it possible that there's some problem with mftrace
(wrong versions of Autotrace or pfaedit or whatever) that could
cause these phenomena?
/Mats
Thomas Willhalm wrote:
Hello,
I'm afraid I'm also stuck with pdf output. It seem like dvips does not
use the correct font. The clefs and notes are garbage. An example is
attached to this email.
The issued command is
dvips -Ppdf -G0 -ulilypond Morgenlicht.dvi
It does not produce any warning or errors, but the result doesn't have
the correct fonts.
"ly2dvi -p Morgenlicht.ly" shows the same problem, but
"dvips Morgenlicht.dvi" gives the correct (bitmap) font.
I recently switched to gentoo linux 1.4RC2, which comes with tetex 1.0.7.
I did my own compilation of lilypond 1.6.6, running
./configure
make
make pfa-fonts
make MAKE_PFA_FILES=1 install
source buildscripts/out/lilypond-profile
texhash
"kpsewhich feta20.pfa" reports
/usr/local/share/lilypond/1.6.6/fonts/type1/feta20.pfa
Any suggestions?
Thomas
_______________________________________________
Lilypond-user mailing list
[EMAIL PROTECTED]
http://mail.gnu.org/mailman/listinfo/lilypond-user
--
=============================================
Mats Bengtsson
Signal Processing
Signals, Sensors and Systems
Royal Institute of Technology
SE-100 44 STOCKHOLM
Sweden
Phone: (+46) 8 790 8463
Fax: (+46) 8 790 7260
Email: [EMAIL PROTECTED]
WWW: http://www.s3.kth.se/~mabe
=============================================
_______________________________________________
Lilypond-user mailing list
[EMAIL PROTECTED]
http://mail.gnu.org/mailman/listinfo/lilypond-user
