As far as I can see from the source code, everything between the % and
the end of the line
should be ignored by LilyPond, no matter if you have a space after the %
or not.
The only special case is %{ which is the start of a block comment.
/Mats
Mark Polesky wrote:
Hi again!
recently I've found some odd behaviors that I
traced down to some ly % comments that had no
space between the % and the next character.
Things like
%what's going on here?
or
%you gotta be kidding me...
And when I changed them both to
% oh, weird...
normal behaviors resumed as far as I can tell.
Is a space required? I didn't see anything
about this in the manual, so if this is an
issue, it should be mentioned.
Thanks again. Lilypond is ze best!
- Mark
_______________________________________________
lilypond-devel mailing list
lilypond-devel@gnu.org
http://lists.gnu.org/mailman/listinfo/lilypond-devel
--
=============================================
Mats Bengtsson
Signal Processing
School of Electrical Engineering
Royal Institute of Technology (KTH)
SE-100 44 STOCKHOLM
Sweden
Phone: (+46) 8 790 8463
Fax: (+46) 8 790 7260
Email: mats.bengts...@ee.kth.se
WWW: http://www.s3.kth.se/~mabe
=============================================
_______________________________________________
lilypond-devel mailing list
lilypond-devel@gnu.org
http://lists.gnu.org/mailman/listinfo/lilypond-devel
