Hi Ed, * Ed Hartnett wrote on Fri, May 05, 2006 at 10:26:19PM CEST: > Ralf Wildenhues <[EMAIL PROTECTED]> writes: > > * Ed Hartnett wrote on Fri, May 05, 2006 at 09:30:02PM CEST: > >> Ralf Wildenhues <[EMAIL PROTECTED]> writes: > >> > * Ed Hartnett wrote on Fri, May 05, 2006 at 02:43:42PM CEST: > >> >> > >> >> Building my package with libtool, I get the following error on my > >> >> linux box when I build, unless I use the --disable-shared flag, in > >> >> which case everything works fine. > >> > > >> > Ouch. Now where'd that -nostdlib go?
There is something mixed up here. Here you probably call an installed `libtool' script: > >> bash-3.00$ libtool --version > >> ltmain.sh (GNU libtool 1.2272 2006/02/20 19:39:16) 2.1a > >> Written by Gordon Matzigkeit <[EMAIL PROTECTED]>, 1996 whereas here you call the script built during package configuration: its output does not match the order of 2.1a output, so I think this has been created with an older version of ltmain.sh and libtool.m4 (but without ./libtool --version I can't tell which, and why it would be buggy). > ./libtool --tag=CXX --config > > # Libtool was configured on host shecky.unidata.ucar.edu: *snip* Maybe you can make sure to have libtoolize from version 2.1a in the PATH, and make sure aclocal finds the Libtool-2.1a macro files (either by installing Automake and Libtool below the same --prefix, or by adjusting the file $prefix/share/aclocal/dirlist to point to the directory where the Libtool-2.1a macro files are installed). Then, regenerate all files (by autotoreconf -vif or similarly). Cheers, Ralf _______________________________________________ http://lists.gnu.org/mailman/listinfo/libtool
