On 11/29/2010 07:48 PM, Mattias Johnsson wrote:
On 30 November 2010 11:34, Joe Smith<j...@martnet.com> wrote:
I was also having a lot of trouble learning anything from running OOo under
gdb. Gdb was acting weird and I couldn't step through the code and poke
around. I ended up trying to do it by adding a printf, rebuild, run, rinse,
repeat. No fun; less progress.
Did you turn off compiler optimisations? I had the same problem (gdb
hopping around in a non-intuitive way, and the values of some useful
variables were optimised out) until I turned them off.
If that's the problem, you can do it by configuring with
--enable-debug, or if you're just building a single module you can do
"build -- debug=t dbglevel=2"
I think "dbglevel=1" also turns them off, and will give less noise,
but I haven't checked.
Cheers,
Mattias
Whee! I was resisting another full build; I didn't realize this was part
of the problem.
Thanks!
<Joe
_______________________________________________
LibreOffice mailing list
LibreOffice@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/libreoffice
