Hi Karl, Jason, Daniel,
OK. Now I have quite a bit code to look at. I wasn't really sure how the mapping between a device and endpoints really works. On 26-03-17 15:39, Karl Palsson wrote: > https://github.com/novatechweb/nt124 > They use a vendor class, not ACM, as ACM doesn't actually have > full modem control support that some people need. But, it's a > well put together package, and you can see how various tricks are > used to make it all hang together nicely. In essence, this is pretty basic as the connection between the programmer and the FPGA is only RX and TX, there isn't that much that I can change. As a bare mininum, I just need "read","write" and "enable/disable". That's it. Thanks all! Cheerio! Kr. Bonne. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ libopencm3-devel mailing list libopencm3-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/libopencm3-devel
