On 09/23/22 11:42, Richard W.M. Jones wrote: > On Mon, Sep 19, 2022 at 03:35:10PM +0200, Laszlo Ersek wrote: >> +At the bottom of the dialog, the C<Refresh disks> button instructs >> +virt-p2v to re-enumerate the fixed hard disks and the removable media >> +drives. (Note that the button will also reset the currently active >> +selections in both of those panels.) This button is useful in >> +combination with the C<XTerm> button on the L</SSH CONFIGURATION >> +DIALOG>: in the XTerm window, you can expose further block devices to >> +the kernel (such as LUNs from iSCSI targets), and the C<Refresh disks> >> +button allows virt-p2v to learn about all the block devices again. >> + >> │ >> Network interfaces │ >> │ > > ^ > Here (and earlier) in the same file ... > >> @@ -239,10 +248,10 @@ the interface to be identified by the operator. >> When you are ready to begin the conversion, press the >> C<Start conversion> button: >> >> - │ >> - [ Back ] [ Start conversion ] │ >> - │ >> - ─ ─ ───────────────────────────────────────┘ >> + │ >> + [ Back ] [ Refresh disks ] [ Start conversion ] │ >> + │ >> + ─ ─ ──────────────────────────────────────────────────────────┘ > > ... I think you need to move the │ (vertical line) in the earlier > sections over to the right to line up.
Will do. I noticed that some of the diagrams were wider than the others, but I didn't notice that such diagrams belonged to different dialogs. Laszlo _______________________________________________ Libguestfs mailing list Libguestfs@redhat.com https://listman.redhat.com/mailman/listinfo/libguestfs
