Le 24/11/2013 19:24, David Kredba a écrit : > Do you have pciutils installed? > If not install it (you can use liveCD or what you used to do first > installation and chroot inside your current system or download it and > copy in if you have USB storage working etc.). > Then start in single mode and post output of lspci -v. > > David > > 2013/11/24 Alan Feuerbacher <alan...@comcast.net>: >> On 11/24/2013 10:33 AM, Bruce Dubbs wrote: >>> Alan Feuerbacher wrote: >>>> On 11/24/2013 12:19 AM, Bruce Dubbs wrote: >> >> Per Ken's suggestion, I added the ethernet driver for my Realtek >> ethernet device, recompiled the kernel, reinstalled systemd/udev from >> scratch. Still no luck. >> >> When linux starts, I see a message: >> "Bringing up the eth0 interface... skipped" >> >> When I try to bring up the network with ifup I get this: >> >> ifup eth0 >> ####### >> Bringing up the eth0 interface... >> Adding IPv4 address 10.0.1.1 to the eth0 interface...Cannot find >> device "eth0" >> ***** >> >> *****face eth0 doesn't exist. >> ####### >> >>>> Ok, then I must have missed something when building the system. What do >>>> I look for in the LFS book to build the right ethernet driver? >>> >>> Bring up a working system and run lsmod. >> >> I get this: >> >> lsmod >> ###### >> Module Size Used by >> x86_pkg_temp_thermal 4511 0 >> ###### I think Bruce was talking about a working distribution (the one you used to build LFS for example). Boot it and run lsmod. The information you get there could indicate the right driver for the kernel.
Before that and if you are still on LFS: ip link list If you see only lo and sit0, it means you do not have the good device driver in the kernel. If you see something like enp0s2, it means something is wrong with the udev files, but at least you can try to bring that interface up. Also, I see: Adding IPv4 address 10.0.1.1 to the eth0 interface Are you sure you want 10.0.1.1? Usually, the .1 address is that of the ethernet hub which connects your local network to the outside world. I'd try 10.0.1.9 (unless you have many computers on your local network, that address should be free...) Regards Pierre >> -- http://linuxfromscratch.org/mailman/listinfo/lfs-support FAQ: http://www.linuxfromscratch.org/lfs/faq.html Unsubscribe: See the above information page
