Jun 21, 2010 10:52:35 AM, [email protected] wrote: On my 'make menuconfig' "Device Drivers>Graphics support> [*] Support for frame buffer devices" screen this is all I have:
--- Support for frame buffer devices
[*] Enable firmware EDID
[ ] Framebuffer foreign endianness support --->
-*- Enable Video Mode Handling Helpers
[ ] Enable Tile Blitting Support
*** Frame buffer hardware drivers ***
< > Cirrus Logic support
< > Permedia2 support
None of the above seem to control yours,
CONFIG_FB_UVESA=m
CONFIG_FB_VESA=y
Could these parameters be one of those "automatics"?
------
Hi Andy,
I did find your parameters in
Device Drivers > Graphics support:
< > Userspace VESA VGA graphics support
[ ] VESA VGA graphics support
I disabled them as shown.
Alas, still the same problem with the recompiled kernel
(the video dies at the end of the boot-up sequence).
I'm attaching the compressed copy of the new 'config'.
Regards,
-- Alex
config.bz2
Description: Binary data
-- http://linuxfromscratch.org/mailman/listinfo/lfs-support FAQ: http://www.linuxfromscratch.org/lfs/faq.html Unsubscribe: See the above information page
