Debugging shows that using the general method properly cleans on each
run, while the method specifying the client-ID shows "No effect"
even while in connected state.
Fixes several connectivity issues seen on specific modems.
Signed-off-by: Koen Vandeputte <koen.vandepu...@ncentric.com>
---
package/network/utils/uqmi/files/lib/netifd/proto/qmi.sh | 14 ++++----------
1 file changed, 4 insertions(+), 10 deletions(-)
diff --git a/package/network/utils/uqmi/files/lib/netifd/proto/qmi.sh
b/package/network/utils/uqmi/files/lib/netifd/proto/qmi.sh
index 1619c2b35eb9..eba0922e57de 100755
--- a/package/network/utils/uqmi/files/lib/netifd/proto/qmi.sh
+++ b/package/network/utils/uqmi/files/lib/netifd/proto/qmi.sh
@@ -97,6 +97,10 @@ proto_qmi_setup() {
}
}
+ # Cleanup current state if any
+ uqmi -s -d "$device" --stop-network 0xffffffff --autoconnect
+
+ # Set IP format
uqmi -s -d "$device" --set-data-format 802.3
uqmi -s -d "$device" --wda-set-data-format 802.3
dataformat="$(uqmi -s -d "$device" --wda-get-data-format)"
@@ -144,11 +148,6 @@ proto_qmi_setup() {
uqmi -s -d "$device" --set-client-id wds,"$cid_4"
--set-ip-family ipv4 > /dev/null
- # try to clear previous autoconnect state
- uqmi -s -d "$device" --set-client-id wds,"$cid_4" \
- --stop-network 0xffffffff \
- --autoconnect > /dev/null
-
pdh_4=$(uqmi -s -d "$device" --set-client-id wds,"$cid_4" \
--start-network \
${apn:+--apn $apn} \
@@ -175,11 +174,6 @@ proto_qmi_setup() {
uqmi -s -d "$device" --set-client-id wds,"$cid_6"
--set-ip-family ipv6 > /dev/null
- # try to clear previous autoconnect state
- uqmi -s -d "$device" --set-client-id wds,"$cid_6" \
- --stop-network 0xffffffff \
- --autoconnect > /dev/null
-
pdh_6=$(uqmi -s -d "$device" --set-client-id wds,"$cid_6" \
--start-network \
${apn:+--apn $apn} \
--
2.7.4
_______________________________________________
Lede-dev mailing list
Lede-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/lede-dev
