The sender domain has a DMARC Reject/Quarantine policy which disallows sending mailing list messages using the original "From" header.
To mitigate this problem, the original message has been wrapped automatically by the mailing list software.
--- Begin Message ---On 2017-10-18 Wed, at 06:32, Valent Turkovic <val...@otvorenamreza.org> wrote: > So if wifi is active, in sta mode but not associated to AP then serial > communication is having issues and is loosing characters when > receiving them. Regardless of this poor behavior, I think you're going to regret it eventually if you don't have some kind of checksum and retransmit logic--implying you're also doing framing. Async serial lines can be tricky, and have non-zero bit error rates. And the framing mechanism needs to be resilient against incomplete packets (meaning, bytes dropped between transmitter and receiver). Newline-separated ASCII records with a hex CRC are not the worst idea, but you need to deal with the situation where a newline gets lost, or you get trash or fewer bytes than you needed. I've used YMODEM before for bulk data. Note that the Arduino Yún uses packets. Jay
--- End Message ---
_______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev
