This patch adds supports for the GL-inet GL-MT300N-V2.
Specification:
- SoC: MediaTek MT7628AN
- Flash: 16 MiB (W25Q128FVSG)
- RAM: 128 MiB DDR
- Ethernet: 1 x WAN (100 Mbps) and 1 x LAN (100 Mbps)
- USB: 1 x USB 2.0 port
- Button: 1 x switch button, 1 x reset button
- LED: 3 x LEDS
- UART: 1 x UART on PCB (JP1: 3.3V, RX, TX, GND)
Installation through Luci:
- The original firmware is LEDE, so both LuCI or sysupgrade can be used.
- Do not keep settings, for sysupgrade please use the -n option.
Installation through bootloader webserver:
- Plug power and hold reset button until red LED blink to bright.
- Install sysupgrade image using web interface on 192.168.1.1.
Signed-off-by: kyson Lok <kyson...@gmail.com>
---
target/linux/ramips/base-files/etc/board.d/01_leds | 1 +
.../linux/ramips/base-files/etc/board.d/02_network | 4 +
target/linux/ramips/base-files/etc/diag.sh | 3 +
target/linux/ramips/base-files/lib/ramips.sh | 3 +
.../ramips/base-files/lib/upgrade/platform.sh | 1 +
target/linux/ramips/dts/GL-MT300N-V2.dts | 127 +++++++++++++++++++++
target/linux/ramips/image/mt7628.mk | 8 ++
7 files changed, 147 insertions(+)
create mode 100644 target/linux/ramips/dts/GL-MT300N-V2.dts
diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds
b/target/linux/ramips/base-files/etc/board.d/01_leds
index 52542ec..101c1c2 100755
--- a/target/linux/ramips/base-files/etc/board.d/01_leds
+++ b/target/linux/ramips/base-files/etc/board.d/01_leds
@@ -186,6 +186,7 @@ fonera20n)
;;
gl-mt300a|\
gl-mt300n|\
+gl-mt300n-v2|\
gl-mt750)
set_wifi_led "$board:wlan"
;;
diff --git a/target/linux/ramips/base-files/etc/board.d/02_network
b/target/linux/ramips/base-files/etc/board.d/02_network
index 80a3bc2..741e702 100755
--- a/target/linux/ramips/base-files/etc/board.d/02_network
+++ b/target/linux/ramips/base-files/etc/board.d/02_network
@@ -175,6 +175,10 @@ ramips_setup_interfaces()
ucidef_add_switch "switch0" \
"1:lan" "2:lan" "3:lan" "4:lan" "0:wan" "6@eth0"
;;
+ gl-mt300n-v2)
+ ucidef_add_switch "switch0" \
+ "1:lan" "0:wan" "6@eth0"
+ ;;
awapn2403)
ucidef_add_switch "switch0" \
"0:lan" "1:wan" "6@eth0"
diff --git a/target/linux/ramips/base-files/etc/diag.sh
b/target/linux/ramips/base-files/etc/diag.sh
index 461f46c..e051dfd 100644
--- a/target/linux/ramips/base-files/etc/diag.sh
+++ b/target/linux/ramips/base-files/etc/diag.sh
@@ -164,6 +164,9 @@ get_status_led() {
miwifi-nano)
status_led="$board:blue:status"
;;
+ gl-mt300n-v2)
+ status_led="$board:red:wlan"
+ ;;
m4-4M|\
m4-8M)
status_led="m4:blue:status"
diff --git a/target/linux/ramips/base-files/lib/ramips.sh
b/target/linux/ramips/base-files/lib/ramips.sh
index 87cb7ff..1e031cd 100755
--- a/target/linux/ramips/base-files/lib/ramips.sh
+++ b/target/linux/ramips/base-files/lib/ramips.sh
@@ -214,6 +214,9 @@ ramips_board_detect() {
*"GL-MT300N")
name="gl-mt300n"
;;
+ *"GL-MT300N-V2")
+ name="gl-mt300n-v2"
+ ;;
*"GL-MT750")
name="gl-mt750"
;;
diff --git a/target/linux/ramips/base-files/lib/upgrade/platform.sh
b/target/linux/ramips/base-files/lib/upgrade/platform.sh
index adad8da..2c50c3c 100755
--- a/target/linux/ramips/base-files/lib/upgrade/platform.sh
+++ b/target/linux/ramips/base-files/lib/upgrade/platform.sh
@@ -64,6 +64,7 @@ platform_check_image() {
freestation5|\
gl-mt300a|\
gl-mt300n|\
+ gl-mt300n-v2|\
gl-mt750|\
hc5*61|\
hc5661a|\
diff --git a/target/linux/ramips/dts/GL-MT300N-V2.dts
b/target/linux/ramips/dts/GL-MT300N-V2.dts
new file mode 100644
index 0000000..5fd40d9
--- /dev/null
+++ b/target/linux/ramips/dts/GL-MT300N-V2.dts
@@ -0,0 +1,127 @@
+dts-v1/;
+
+#include "mt7628an.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/{
+ compatible = "GL-MT300N-V2", "ralink,mt7620an-soc";
+ model = "GL-MT300N-V2";
+
+ chosen {
+ bootargs = "console=ttyS0,115200";
+ };
+
+ memory@0 {
+ device_type = "memory";
+ reg = <0x0 0x8000000>;
+ };
+
+ gpio-leds {
+ compatible = "gpio-leds";
+
+ usbpow {
+ label = "gl-mt300n-v2:blue:usbpow";
+ gpios = <&gpio0 11 1>;
+ };
+
+ wan {
+ label = "gl-mt300n-v2:blue:wan";
+ gpios = <&gpio1 11 1>;
+ };
+
+ wlan {
+ label = "gl-mt300n-v2:red:wlan";
+ gpios = <&gpio1 12 1>;
+ };
+ };
+
+ gpio-keys {
+ compatible = "gpio-keys-polled";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ poll-interval = <20>;
+
+ reset {
+ label = "reset";
+ gpios = <&gpio1 6 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_RESTART>;
+ };
+
+ BIT_0 {
+ label = "BIT_0";
+ gpios = <&gpio0 0 1>;
+ linux,code = <0x100>;
+ };
+
+ BIT_1 {
+ label = "BIT_1";
+ gpios = <&gpio0 3 1>;
+ linux,code = <0x101>;
+ };
+ };
+
+};
+
+&pinctrl {
+ state_default: pinctrl0 {
+ gpio {
+ ralink,group = "refclk", "gpio", "wled_an", "p0led_an",
"p1led_an", "i2c", "i2s";
+ ralink,function = "gpio";
+ };
+ };
+};
+
+ðernet {
+ mtd-mac-address = <&factory 0x04000>;
+};
+
+&wmac {
+ status = "okay";
+ ralink,mtd-eeprom = <&factory 0x04000>;
+};
+
+&spi0 {
+ status = "okay";
+
+ m25p80@0 {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <10000000>;
+ m25p,chunked-io = <32>;
+
+ partition@0 {
+ label = "u-boot";
+ reg = <0x0 0x30000>;
+ read-only;
+ };
+
+ partition@30000 {
+ label = "u-boot-env";
+ reg = <0x30000 0x10000>;
+ read-only;
+ };
+
+ factory: partition@40000 {
+ label = "factory";
+ reg = <0x40000 0x10000>;
+ read-only;
+ };
+
+ partition@50000 {
+ label = "firmware";
+ reg = <0x50000 0xf00000>;
+ };
+ };
+};
+
+&ehci {
+ status = "okay";
+};
+
+&ohci {
+ status = "okay";
+};
diff --git a/target/linux/ramips/image/mt7628.mk
b/target/linux/ramips/image/mt7628.mk
index 6bb04ea..90c7969 100644
--- a/target/linux/ramips/image/mt7628.mk
+++ b/target/linux/ramips/image/mt7628.mk
@@ -26,6 +26,14 @@ define Device/miwifi-nano
endef
TARGET_DEVICES += miwifi-nano
+define Device/gl-mt300n-v2
+ DTS := GL-MT300N-V2
+ IMAGE_SIZE := $(ralink_default_fw_size_16M)
+ DEVICE_TITLE := GL-iNet GL-MT300N-V2
+ DEVICE_PACKAGES := kmod-usb2 kmod-usb-ohci kmod-usb-ledtrig-usbport
+endef
+TARGET_DEVICES += gl-mt300n-v2
+
define Device/vocore2
DTS := VOCORE2
IMAGE_SIZE := $(ralink_default_fw_size_16M)
--
1.9.1
_______________________________________________
Lede-dev mailing list
Lede-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/lede-dev
