On Wed, Feb 22, 2017 at 1:36 PM, Felix Fietkau <n...@nbd.name> wrote: > On 2017-02-21 23:10, Sergey Ryazanov wrote: >> Hello, >> >> I tried to install latest LEDE to RB411AH board. Sysupgrade worked >> fine, but device now do not boot at all. Bootloader claims that it >> could not find kernel :( >> >> I tracked down the situation and found that the kernel partition image >> generated with assumption that any 64Mb NAND flash IC consists of >> pages, the size of which is 512 bytes with an 8-byte spare area. But >> my board equipped with Toshiba NAND flash, which consists of pages, >> the size of which is 2048 bytes with an 64-byte spare area. >> >> Even worse, after such reflashing with the corruption of the page >> structure, kernel starts thinking that pages are bad and they could >> not be used anymore. So I had to install vendor's firmware back with >> help of vendor utility to recover pages structure. >> >> To fix this I see several solutions: >> >> 1. Generate more images, one for each combination of flash and page >> sizes (e.g. xxx-64m-512-sysupgrade.bin, xxxx-64m-2048-sysupgrade.bin) >> Pros: quick realization, no sysupgrade code modification >> Cons: exponential growth of number of images, unusable due to endless >> mess with this set of images. > > By the way, the 64m image is only named as such, because I didn't know > that there were any devices with 64M nand and 2048 byte page size. > You should be able to flash the nand-large image on your device just fine.
Ok. I will try. > To prevent flashing errors like the one you had, maybe it would be a > good first step to add metadata to the image and make sysupgrade set the > board type to nand-64m or nand-large depending on the flash parameters. I am not familar with image metadata. Will check it. -- Sergey _______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev
