Have you tried the ath10k-ct driver? I think it should at least
support the radios if you put on the right firmware. Not sure about the rest
of the board.
Thanks,
Ben
On 11/12/2016 09:42 AM, Matthew McClintock wrote:
On Fri, Nov 11, 2016 at 5:03 PM, Christian Mehlis <[email protected]> wrote:
Hi Matthew,
I took your patches to my tree. They are for Linux 4.7, so I tried to make
Lede build with that Linux version.
I ran into some trouble with musl+netifd (fixed it). Now compat-wireless
seems to expect an older Kernel:
compat-wireless-2016-10-08/backport-include/linux/netdevice.h:337:5: error:
'struct net_device' has no member named 'trans_start'
dev->trans_start = jiffies;
The member was kicked in 4.7.
In case someone is willing to help, I'm open for code.
I can't help much, since QCA declined to give me a board. Did you try
regenerating the compat-wireless against the newer kernel? I never did
much on the wifi side, was alway doing everything else.
If you compare the ChromeOS tree I shared it's a backport to 3.18, so
some subset of patches in that list will backport to 4.4 pretty
easily.
-M
_______________________________________________
Lede-dev mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/lede-dev
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com
_______________________________________________
Lede-dev mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/lede-dev
