Because the WAN port is handled by the internal AR8327N switch, the
device should use swconfig_leds trigger to handle the link activity
of the WAN LED. This has the added bonus that the WAN LED will now
go dark if there's no ethernet cable connected to the WAN port.
Signed-off-by: Christian Lamparter <chunk...@gmail.com>
---
target/linux/apm821xx/base-files/etc/board.d/01_leds | 3 ++-
target/linux/apm821xx/nand/config-default | 2 ++
2 files changed, 4 insertions(+), 1 deletion(-)
diff --git a/target/linux/apm821xx/base-files/etc/board.d/01_leds
b/target/linux/apm821xx/base-files/etc/board.d/01_leds
index 76edbd1..b34f5fe 100755
--- a/target/linux/apm821xx/base-files/etc/board.d/01_leds
+++ b/target/linux/apm821xx/base-files/etc/board.d/01_leds
@@ -29,7 +29,8 @@ mbl)
wndr4700)
ucidef_set_led_ide "sata" "SATA" "wndr4700:green:hd"
- ucidef_set_led_netdev "wan" "WAN (green)" "wndr4700:green:wan" "eth0.2"
+ ucidef_set_led_switch "wan_green" "WAN (green)" "wndr4700:green:wan"
"switch0" "0x20"
+ ucidef_set_led_netdev "wan_yellow" "WAN (yellow)" "wndr4700:yellow:wan"
"eth0.2" "tx rx"
ucidef_set_led_usbport "usb3" "USB3" "wndr4700:blue:usb" "usb2-port1"
"usb2-port2" "usb3-port1" "usb3-port2"
ucidef_set_led_wlan "wlan2g" "WLAN2G" "wndr4700:blue:wlan" "phy0tpt"
ucidef_set_led_wlan "wlan5g" "WLAN5G" "wndr4700:blue:wlan" "phy1tpt"
diff --git a/target/linux/apm821xx/nand/config-default
b/target/linux/apm821xx/nand/config-default
index d6328fd..d17c2c9 100644
--- a/target/linux/apm821xx/nand/config-default
+++ b/target/linux/apm821xx/nand/config-default
@@ -39,4 +39,6 @@ CONFIG_UBIFS_FS=y
# CONFIG_UBIFS_FS_ADVANCED_COMPR is not set
CONFIG_SENSORS_LM90=y
CONFIG_SENSORS_TC654=y
+CONFIG_SWCONFIG=y
+CONFIG_SWCONFIG_LEDS=y
CONFIG_WNDR4700=y
--
2.10.2
_______________________________________________
Lede-dev mailing list
Lede-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/lede-dev
