anyone can help? its already working. Just need guidance about best place to put the configuration for it and register the callback...
Thanks On Tue, Oct 25, 2016 at 9:13 PM, Juan Rios <anonb...@gmail.com> wrote: > Hello again, > I have been working on adding support for this router with the > help of SCApi and we got it to the point that Ethernet ports works, > leds and buttons works and wifi card 0xa8d6 43222 works. > > The wifi card don't have sprom and I had to write a patch to add > fallback sprom support for this card. > > The sprom is not located in flash or at least I could not find it. I > used the logs from original firmware and information from broadcom > architecture to make it and put the interesting values and it works. > > To supply sprom buffer I need the mac address of the interface. I want > to use the Ethernet mac address + 2. The Ethernet mac address is > stored in mtd at certain offset. > > Where should be the registration of the sprom fallback function?. > Right now I did it in the b43_pci_ssb_bridge_init function from the > drivers/ssb/pci_b43_bridge.c file. > > Also It is needed a way to specify the mtd partition where the mac > address is stored, the offset and the increment needed to the mac > address. Where and how should this be put? > > Right now there is only three lantiq routers with broadcom wifi card > that I know of and may be in the same situation. > > Regards > Juan Rios _______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev
