Am 20.06.2016 um 07:19 schrieb John Crispin:
On 20/06/2016 05:15, Zhao, Gang wrote:
Hi, Mathias Kresin
On Sun, Jun 19, 2016 at 10:30 PM, Mathias Kresin <d...@kresin.me> wrote:
So far the network in failsafe is setup only for one board. Use the
eth0 interface as lan interface for all boards for now.
If a board has its lan interface(s) on another eth, a special
handling based on the board name can be added.
Signed-off-by: Mathias Kresin <d...@kresin.me>
---
.../lantiq/base-files/lib/preinit/05_set_preinit_iface_lantiq | 10 +---------
1 file changed, 1 insertion(+), 9 deletions(-)
diff --git
a/target/linux/lantiq/base-files/lib/preinit/05_set_preinit_iface_lantiq
b/target/linux/lantiq/base-files/lib/preinit/05_set_preinit_iface_lantiq
index 3d7fabf..7ed0fab 100644
--- a/target/linux/lantiq/base-files/lib/preinit/05_set_preinit_iface_lantiq
+++ b/target/linux/lantiq/base-files/lib/preinit/05_set_preinit_iface_lantiq
@@ -3,15 +3,7 @@
. /lib/functions/lantiq.sh
set_preinit_iface() {
-
- board=$(lantiq_board_name)
-
- case "$board" in
- TDW8970)
- ifname=eth0
- ;;
- esac
-
+ ifname=eth0
What about to add a default branch in case statement?
*)
ifname=eth0
;;
i am wondering if we should add a switch default config here or simply
reset the switch with vlans turned off
Is it really necessary? I mean the failsafe kicks in long before the
network config and vlan setup is done.
I've tested this with a board using the xrx200 in-SoC switch and a board
using a RTL8306G switch. In both cases it wasn't necessary to turn off
the vlans since they had not yet been configured.
Mathias
_______________________________________________
Lede-dev mailing list
Lede-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/lede-dev
