On Thu, 15 Oct 2015 09:13:19 +0000, Mark Morgan Lloyd <[email protected]> wrote:
>$ sudo mv old_directory_name new_directory_name I did: sudo mv /usr/local/share/lazarus /usr/local/share/lazarus_old >$ sudo rm -r directory_name > >or even > >$ sudo rm -rf directory_name What is the difference? >create etc. a directory for Lazarus: > >$ cd /usr/local/share >$ sudo mkdir lazarus >$ sudo chown markMLl:staff lazarus >After that you can fill the directory using svn or whatever and compile >it, without needing root. I already created a directory /home/pi/development where I checked out lazarus trunk into subdir lazarus. So the sources are there. In these discussions I have understood that lazarus can be handled entirely within the home dir... > >As discussed elsewhere, you need to sort out logging into the RPi as >"yourself" rather than root My problems earlier were again following the tutorial website where everything was done after sudo su... That part is entirely fixed now! :) ---- Lazarus has been compiling bigide ---- ~/development/lazarus $ time make bigide Result: real 17m57.477s user 14m15.830s sys 2m26.930s My Rasberry Pi2 was set up with 1000GB swap and to boot into the command line interface (to not waste memory) for the build operation above. I will now switch out of this thread and create a new one for installation of Lazarus on a Raspberry Pi2 since I still have problems. -- Bo Berglund Developer in Sweden -- _______________________________________________ Lazarus mailing list [email protected] http://lists.lazarus.freepascal.org/mailman/listinfo/lazarus
