Larry, program 133 says no caller ID will go to the xdp port if in parallel mode, but it will work on the digital side. Brad
-----Original Message----- From: kxt-boun...@kxthelp.com [mailto:kxt-boun...@kxthelp.com] On Behalf Of Larry Sent: Sunday, June 03, 2012 3:11 PM To: Panasonic KX-T telephone system discussion list Subject: Re: KX-T: KX-TD171 & TD1232 - final works fine with a sony itid70 phone (only thing on analog port) also- first setup seemed flaky- at one point i set for paralleled extension (390/391). after that i went back to my first settings and they seemed to work. a cabinet power off/on might be needed to push changes to the modules. T1 card ;-) hope you get yours working -larry I stuffed a 171 in my shop 816-3 set expand(109) to E set the following using port 9 (171 E1=port 1 (133)) then enabled xdp port 9. (600) when i call in i get double ring on ext 209 (xdp analog pair) then HEAR cid tone on butt set then the next rings are single rings, and no more tones. cid is fine on digital phones. but the cid tone will not display on 3 different cid boxes, but one will blink like it tried. the tone sounds too short for name and number. need to find my junk box with the cid box assortment. the double ring bothers me too, I have devices (fax) that will not decode after a double ring. will see if there is a fudge bit in 990 to change level or format. -larry, _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
