While working out the bugs in the new phone system, I discovered that for some reason when dialing certain extension numbers across ports, something a little odd happens.
I have two ports set up for two different phone numbers with two different outgoing company messages. One port is for my organ service company, and the other is set up for the home phones. Extension 110 is a phone in the home side Port 1. If I dial Extension 110 from port 1 which is set up for CO1 everything works fine. If I dial into CO2 every extension in the system works on the port 1 side okay with the exception of Extension 110. After entering extension 110, and after the "one moment please" message, you hear no hook switch flash and then two touch tones in the phone receiver. There's a long pause of silence and then the system finally puts you on hold and you hear MOH. In a few seconds the system comes back on the line and it starts with the Company Name Greeting again as if it is a new incoming call. Trying Extension 110 again creates the same scenario. This does not happen with any other extension number in the system. I thought it might be a small numbering glitch which I can not correct, so I changed Extension 110 to 115 and no more problems. This may be something that no one has discovered, and since the TVS225 is a 2+ year old system and no longer manufactured, it may not be that important but I thought I would share it. Donald R. Resor Los Angeles _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
