You have to change the settings from ''co'' to ''extension'' for all ports in program [424] so you can use the PSTN lines. When the ISDN lines are activeted you have to change the settings back as it was. Note that after this programming you must restart the system, so that the changes have affect. Chris ----- Original Message ----- From: "SAM ." <[EMAIL PROTECTED]> To: <kxt@kxthelp.com> Sent: Wednesday, January 04, 2006 12:56 PM Subject: KX-T: config co isdn and analog
> Hi!. > I have a kx-td1232sp with 3 extension packs, 2 for 8 extension add and 1 > for > 4 idsn lines. the isdn lines aren´t activated yet. I have conected the two > outside analog lines to t1/t2 jack, but not the isdn lines. I was unable > to > receive or sending otutside calls, the message co not assigned is visible > in > the lcd (terminals are type digital t75xx) With the software Programmator > i > view all co assigned at every extension. > > In a internal note i readed the expansion module isdn solape the analog co > lines 1 to 6 and is necessary to connect the analog lines only in the > 6-7-8-9 not in the 1-2-3-4-5-6????? > > Please, exists any software like "programmator" for configuring the > kx-td1232???? > > In term to identify version (dash???) and rom .... where is this > information? and .. is possible to upgrade and old rom to a new?????? > where > is the info to make this????? > > thanks, and sorry for my bad bad english. > > > > _________________________________________________________________ > KX-T Mailing list --- http://kxthelp.com/ > Subscription changes: http://kxthelp.com/mailman/listinfo/kxt _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
