These phones, and the 7400s, were designed for on-hook headset use, but the speakerphone is disabled while you do it.
press: program 99 9 2 hold program
to go back to normal, repeat with 1 insead of 2
By sheer coincidence (I've only been on this list for two or three days), someone at the office asked me about this today and I had the answer! Thanks.
However, I find two differences in my experience vs. the above instructions, and I would appreciate feedback and comments on them:
1. I find that "store" is equivalent to "enter" or "OK" and that "hold" is equivalent to "escape" or "cancel". I tried this sequence several times as stated, using [program]99,9,2[hold][program] and nothing worked. Out of intuition I tried "store" and it worked. Then in testing I found that "hold" cancelled and "store" committed.
2. The 7433 phone I was using (with a Plantronics headset, likely not an expensive one) would not accept 1 for "handset" and 2 for "headset". It would start at whatever was currently selected (e.g. "handset") and pressing 1, 2, or both would toggle just once to the other setting, for example handset --> headset or headset --> handset. After toggling ONCE, all I could do was press "store" or "hold" and then try again.
Is this normal? Is this an error in the procedure above, or a quirk in my equipment, or something else?
Again, though, it eventually worked. Thanks!
-- Rodolfo J. Paiz [EMAIL PROTECTED]
_________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
