My system is a -0 with an upgraded EPROM, so the manual doesn't cover things like voice mail transfer. (I don't even have a page 3-137.) My assumption that VTR would work in my configuration was based on information in the VPS75 manual. On page 4-17 of that manual, it says that the voice mail transfer button can be used with D-PITS or Inband Signaling.
The way I see it, there are 4 possibilities at this point: 1. The 624's VTR is incompatible with the VPS75. 2. I haven't set all the parameters properly on the 624 to get VTR working. 3 The VPS75 manual is wrong, and I need APT or D-PITS. 4. My Inband Signaling parameters need to be tweeked. Does anyone have any ideas of how I should proceed from here? Optimally, I'd like to get VTR working. If I can't, what are my options? I know I can set up call forward on busy/no answer, but that means that the person I transfer will need to wait for the no answer timeout before getting to the mailbox. It also means that the FWD/DND light will be constantly flashing, which I find really annoying. (Is there any way to get that light to stop flashing?) Any input would be most appreciated. Thanks, Mark ----- Original Message ----- From: "Randy Dell" <[EMAIL PROTECTED]> To: "Mark Pauker" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> Sent: Sunday, March 02, 2003 8:26 PM Subject: Re: Voicemail Transfer Not Working > In my 624 manual it says on page 3-137 1.3 Special Features for APT > Integration. That Voice Mail Transfer only works with APT not inband > integration. > > > rd > ----- Original Message ----- > From: "Mark Pauker" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Sunday, March 02, 2003 10:01 PM > Subject: KX-T: Voicemail Transfer Not Working > > > I'm trying to get voicemail transfer working between my KX-TA624 and my > VPS75, but it doesn't seem to be working. According to the manual, this > feature should work using inband integration, but when I press the VTR > button, all I get is 3 quick beeps. Have I done something wrong? > > To set this up, I went into program mode, pressed the button I wanted to use > for VTR, dialed 94 (at which time the screen said VTR), then entered 115 > (which is the extension where the VPS port 1 is plugged into), and then > pressed the Store button. Am I missing something? Is there another > parameter I need to set somewhere? > > Any help would be appreciated. (I'm soooo close now.) > > Thanks, > Mark > > > _________________________________________________________________ > KX-T Mailing list --- http://kxthelp.com/ > Subscription changes: http://kxthelp.com/mailman/listinfo/kxt > > _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
