To summarize the postings: Group Priority for Automatic Access (Dial 9) is based on the settings from program 103.
WITHIN a group, access is as follows: 1. Preference is given to CO lines connected to the SAME cabinet. 2. Preference is then given based on the setting from program , titled LINE HUNT. It can take the value Small->Large OR Large->Small. It is found (under the TIE TRG Setting) and, as has been correctly pointed out, is program 440. If a CO is busy (or you are not allowed to use it for outgoing calls), then the system goes to the next CO down the line. It has been suggested that if you have a Centrex line hunt group (CO1->CO2->CO3->CO4), then you should set LINE HUNT for outgoing calls to Large->Small to minimize the chance of "glare" (meaning that an incoming call arrives at the EXACT moment that someone accesses a CO for outgoing use). I've never seen it to be a practical issue. Marc [EMAIL PROTECTED] _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
