Some SLT's are polarity sensitive. They will not break dial tone
and/or ring unless they have correct polarity. I believe that some
princess and/or trimline telephones were sensitive to polarity.
Some more questions:
When you pick up the handset, does pressing the buttons
generate tones, break dial tone, and allow you to dial another
extension?
Have you checked polarity on the first pair to the jack?
Is the first pair to the jack split across two extension
pairs to the KX-TD? If so, you might be able to answer the phone but
receive no ring voltage.
Have you tried disconnecting everything, powering down,
powering up, and waiting before connecting anything?
Before sending the unit in for repair, I would recommend
reset the switch and testing ringing in order to rule out software
glitches.
Paul H. Gusciora
San Rafael, CA
=====
From: "Charles P." <[EMAIL PROTECTED]>
To: "Michael Duffy" <[EMAIL PROTECTED]>,
"KXTD Help \(E-mail\)" <[EMAIL PROTECTED]>
Subject: KX-T: Re: SLT Not Ringing
Date: Tue, 8 Oct 2002 12:16:09 -0400
Michael,
Are the slt's alone on the jacks or are they plugged in with a digital
phone?
I know you said you tried xdp on and off but I just want to be sure.
> 691 parallel on or off,
Also, the parallel on/off code should be 391 not 691 but I assume that was
probably a typing error.
A few other questions that might help narrow this down:
How many slt's are you using?
Did you try them on many other ports? such as on an expansion card port?
Do the slt phones work properly on a direct line (they don't have a hidden
"ringer off" switch)? Try one on a fax line.
Or It could be the ring generator as Matt said.
Charles
----- Original Message -----
From: "Michael Duffy" <[EMAIL PROTECTED]>
To: "KXTD Help (E-mail)" <[EMAIL PROTECTED]>
Sent: Tuesday, October 08, 2002 10:52 AM
Subject: KX-T: SLT Not Ringing
>
>
> Dear KXTD
>
> I have a KXTD1232E V6 and the SLT's are not ringing but you can answer the
> call if you pick it up. I have tried it every way including programmed
code
> 691 parallel on or off, enabling and disabling the XDP.Also check the
> programming on code 603 and 604
>
> I have default the system on two occasions
>
> Would there be a fault on the system
>
>
> Regards
>
> Michael
>
> HOMELINE
_________________________________________________________________
KX-T Mailing list --- http://kxthelp.com/
Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
