That would work if it is the correct diameter. Had I have known ACS Products was going to stop producing those spinners, I would have pulled molds of the bulkheads and fabricated new ones from CF. Back tracking and building them from scratch could be done, but I just don't have the time any time soon. I don't expect the guy that bought my plane would want to ship the spinner bulkheads to me from Canada so I could pull molds from them. ![]()
-Jeff Scott
Arkansas Ozarks
Sent: Thursday, February 23, 2023 at 3:05 PM
From: "n357cj via KRnet" <krnet@list.krnet.org>
To: "KRnet" <krnet@list.krnet.org>
Cc: "n357cj" <n35...@ptd.net>
Subject: KRnet> bulkheads for spinners
From: "n357cj via KRnet" <krnet@list.krnet.org>
To: "KRnet" <krnet@list.krnet.org>
Cc: "n357cj" <n35...@ptd.net>
Subject: KRnet> bulkheads for spinners
What are thoughts on the bulkhead shown on this site?
I can make this in a couple hours for front and back bulkheads. I just have a bit of reservation because I had bulk heads that had solid shaped outside ring instead of the tabs on this one.
Thanks,
Joe Horton
-- KRnet mailing list KRnet@list.krnet.org https://list.krnet.org/mailman/listinfo/krnet
