Jeff Thanks for the info. That’s a good idea and starting point Sent from my iPhone
> On Mar 22, 2019, at 9:13 PM, Jeff Scott via KRnet <krnet@list.krnet.org> > wrote: > > >> Subject: KR> RPM source for use with Dynon Skyview >> >> Netters >> Need to find out what others have used as a rpm source that works with a >> Dynon Skyview. The manual I have dated September 2013 for use with firmware >> version 7 is not very specific. I know that William has suggested a flywheel >> tooth counter like the Stewart automotive. Is there any other ways to pick >> up a signal. I am using a 3.0 liter Corvair as my engine. Can I get a signal >> form the coils or the dual electronic pickups in my distributor? Any light >> that you can shed would be helpful. >> Pete Klapp > >> > ----------------------------- > > Pete, > > I've not wired a Dynon, but in your case, I would assume the + side of an > ignition coil to be the equivalent of the P-lead on a magneto. The voltage on > the primary side of your coil may be a bit lower than the voltage on a > P-lead, but I would use a 30 kΩ "pull up" resistor the same as instructed to > connect a "P-lead" and go from there using the same instructions as outlined > for connecting to a "P-lead", then configure for a 6 cyl engine. The pulse > count should be the same as any 6 cyl Continental or Lycoming firing from a > magneto. > > -Jeff Scott > > _______________________________________________ > Search the KRnet Archives at > https://www.mail-archive.com/krnet@list.krnet.org/. > Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. > see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change > options. > To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org _______________________________________________ Search the KRnet Archives at https://www.mail-archive.com/krnet@list.krnet.org/. Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options. To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org
